-
Quatuor -
Woodwinds
- » Diatonic clarinet
- » Chalumeau
- » Irish Whistle
- » Breton flute
- » Breton bombards
-
Techniques
-
Percussions
-
Miscellaneous
-
Workshop
- » Enhanced Clamps
- » A two-handed gouge
- » Convert inches into millimeters
- » Finger planes
- » Instrument making vise
- » My Metric String action gauge
- » Purfling chisel
- » Purfling cutter
- » Radius sanding block
- » Resawing on the bandsaw
- » Soft vise jaws for the luthier
- » Thickness Gauge
- » Thickness Punch
- » Thickness sander
- » Toothed blades
-
Vintage furnitures restoration
-
Works
-
Finishing recipes
-
Wood knowledge
-
Workshop
- » Bandsaw blade tension
- » Carving platform
- » Centering calipers
- » Cordless drill to corded
- » Disk Sander
- » Manual feeder blocks for table saw
- » My branding mark
- » Push Sticks
- » Router plane
- » Scartch Stock
- » Scraping plane
- » Silver soldering a bandsaw blade
- » Spokeshave
- » Startup and blade tension
- » Tenon saw
- » Tenoning Jig
-
My Woodturnings
- » Jewellery
- » Bowls
- » Miscellaneous
- » Pencils
- » Spinning tops
- » Lamps
-
Woodturning shop
-
Works
-
Leather Work
-
Technique
- » Lacing
-
Metal working
-
FOR THE LUTHIER
-
The softwares that I use
- » Bigprint
- » Qcad
- » Photofiltre
- » Audacity
- » Melody Assistant
-
Android in the workshop
visitors
visitors online
- Luthiery work
- Mandolins
- Quatuor
- Woodwinds
- Percussions
- Miscellaneous
- Woodworking
- WOODTURNING
- My Woodturnings
- Vintage furnitures restoration
- Works
- Finishing recipes
- Wood knowledge
- WOODTURNING
- Leather work
- Technique
- Works
- Softwares
- FOR THE LUTHIER
- The softwares that I use
- Android in the workshop
- Some tricks
- Tooling
- The luthier workshop
- The woodturner's workshop
- Wood Workshop
- Miscelaneous
- My tools on Homemadetools.net
This hammer is very specific, it is designed for metal engraving, for the work with chisels.
I have felt attracted by the Engraving craftsmanship for a while now, but that requires a lot of learning. I start by making my tools.
For those interested in engraving, I recommend the excellent site "Gravures et Couteaux", from Jean Santos (in French).
The head, made of turned steel, only weighs 80g. The face is slightly rounded and large enough to offer a good hitting surface area for the chisel.
The tool must allow frequent and light taps, at a good pace. The balance, and the ergonomy, in particular the bottom of the handle, with a pear shape, shifted towards the front are well suited for that work.
And here is a first chisel to work together with the hammer. The tip is HSS, grounded in a lozenge shape.
And now, I only need a lot of practice ...
Unless explicitly specified, all works presented on this page are released under a
Creative Commons BY-NC-SA International License.
Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License
© 2004-2018
