By continuing your navigation on this site, you accept the use of cookies to offer you contents and adapted services. Legal Notice.
 
 
 
 
You are here :   Welcome » Thickness sander
 
 
Find La Belle Note on FacebookJoin me on HomemadeTools.net

Thickness sander

My thickness sander

The thickness sander is one of the most usefull machine to the luthier. It is a drum sander, relatively powerfull, that allows to sand some thin pieces on the thickness, but on a large width.

The thickness sander allows to set thickness (about 2mm or so) to  some instrument tops, fingferboards, bindings, backs and ribs.

We can find some comercial versions of this machine, but it is relatively simple to build one, that will be much more versatile than the commercial versions.

My thickness sander, in action : 

As soon as I do not need it anymore, it becomes a table :

In addition, in the prolongation of the roll shaft, it is possible to install an extension shaft, supporting a buffing wheel.

See the diaporama for more details on this thickness sander.

The originality of this machine stands in its table lift system, that can be seen in this video :

Comments are welcome.

Buxus/Christophe




Unless explicitly specified, all works presented on this page are released under a
Creative Commons BY-NC-SA International License.
Licence Creative Commons
Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License




Creation date : 17/06/2013 : 23:17
Last update : 18/06/2013 : 00:46
Category : Luthiery work - Workshop
Page read 20405 times